The boot and shoe dryer will safely dry any shoes, boots or waders overnight. Drying time may be shorter depending on the material and the degree of dampness.

1. Make sure footwear is free of excess dirt or mud. You can wash and dry your footwear without damage to any type of material. If wetness is caused by perspiration, shoes can be washed first, or simply dried directly on the dryer.

2. Do not place the dryer close to a second heat source, such as a furnace register. This will prevent unwanted heat being pulled into the dryer. Keep air vents at the back of the base clear of obstructions. If obstructed, the intake of air will be reduced and delay or prevent the drying process.

3. Place appropriate foot piece extensions on the tops of the drying tubes. The 6 inch extensions are included and look just like the tubes.

4. To turn on the shoe dryer, simply plug it in. The dryer will get warm, reaching its maximum temperature in 10 minutes, but it does not get hot. Because there are no fans or moving parts, the dryer does not blow hot air or make noise.

5. Place shoes or boots upside down over foot pieces and tubes.

a. Make sure the toe is higher than the heel; otherwise, the toe may not dry thoroughly.

b. Loosen the tongue and laces for a loose fit between the footwear and the tubes. This will allow air to circulate properly. If footwear has elastic tops, roll up once to loosen the fit.

c. There must be at least 6 inches of clearance between the top of the boot or shoe and the base of the dryer. This will allow the warm air to move freely for proper drying. Remember to use extensions when necessary. Knee boots require 6" extensions. Hip boots require one pair of 12" extensions and chest waders require two pair of 12" extensions.